Adding Notch to PCI 5V Card to Fit In 3.3V PCI Slot

I recently ordered a pci-to-usb card and the pcb wasn’t exactly the one as shown in the picture. It’s missing the cutaway to fit in universal or 3.3v PCI slots. Without it, it will only fit in 5V slots. My motherboard only has one 5V slot, and it’s covered up by the video card.


Looking at the specs for the VIA 6216L USB controller chip, it is suppose to run at 3.3V, meaning there should be a notch there. So I looked up the pin configuration for PCI slot, made a cut with a hacksaw removing pins 12 and 13, and it slipped right in. Works as expected.



This entry was posted in Uncategorized. Bookmark the permalink.

3 Responses to Adding Notch to PCI 5V Card to Fit In 3.3V PCI Slot

  1. anonymous says:

    What card (maker/model) is it?
    Where does it draw the power for the USB peripherals? The bus provides them 5V to operate.

Leave a Reply to anonymous Cancel reply

Your email address will not be published. Required fields are marked *